How to Clean Your Vape Kit for Better Flavour & Hygiene

Is your fresh fruit flavour tasting a bit flat? Your go-to menthol tasting ‘meh? It might not be the e-liquid. We show you how to easily deep clean your device in 5 minutes to restore that perfect Gold Bar taste.

We all know we should clean our vape kits, but let’s be honest, most of us put it off until something goes wrong. However, residue build-up doesn't just look messy; it actively ruins your vaping experience. Old e-liquid oxidises in the tank, creating a bitter aftertaste, while dust in the mouthpiece is a hygiene hazard none of us want to think about.

The good news is that you don't need any special equipment to get your kit sparkling again. Here is our simple, step-by-step guide to cleaning your pod vape kit for better hygiene and purer flavour.

Key Takeaways:

The Safety Rule: Never wash the battery or the metal coil with water.

The Flavour Killer: Old liquid residue causes "flavour ghosting," ruining new flavours.

The Pro Tip: Use separate pods for different flavour profiles (e.g., one for Menthol, one for Fruit).

The Easy Way: Gold Bar Prefilled Pods give you a fresh, clean mouthpiece with every new pod.

Shop Vape Kits

What You Need

You don't need expensive ultrasonic cleaners. You just need:

Warm water
Paper towels
Cotton buds
5 minutes of patience

The "Do Not Wash" List: Crucial Safety Rules

Before you start, it is vital to know what cannot get wet.

The Coil: Never wash the metal coil. Water ruins the cotton wick inside, and it will never dry out properly. If a coil is dirty or burnt, replace it.

The Battery: Never submerge your device. Electronics and water do not mix.

Step 1: The Tank and Pod

This is where most of the old e-liquid residue hides.

Remove the Pod: Take the pod out of the device.

Remove the Coil: If your pod has a removable coil, pull it out and set it aside on a dry tissue. If the coil is built-in (non-removable), you can only gently wipe the outside; do not submerge it.

Rinse: Rinse the empty plastic pod under warm running water. You can half-fill it, cover the holes with your fingers, and give it a good shake to dislodge stubborn liquid.

Dry: Shake out as much water as possible.

Step 2: The Mouthpiece

Pocket lint, dust, and condensation love to gather inside the chimney of the mouthpiece.

Twist a corner of a paper towel into a thin needle shape.
Push it down the chimney of the mouthpiece.
Twist it around to wipe the inner walls clean. You might be surprised at what comes out!

Step 3: The Battery Contacts

Connection issues often happen because e-liquid leaks onto the gold pins where the pod connects to the battery.

Take a dry cotton bud.
Gently wipe the gold contact pins inside the top of the battery unit.
Wipe the base of the pod where it touches the pins.
This ensures your device fires instantly every time you draw.

Step 4: Drying Time

This is the step most people skip, but it is the most important.

Do not refill your pod immediately. If there are droplets of water left in the chimney or tank, they will boil when you vape, causing hot "spit-back" and diluting your flavour.

Let the pod air-dry on a piece of kitchen roll for at least 15–20 minutes.

Can I Change Flavours in the Same Coil?

Technically, yes. Practically, we wouldn't recommend it.

If you have been vaping a strong flavour like Spearmint and then fill the tank with Strawberry, you will experience "Flavour Ghosting." The mint is locked into the cotton wick, and for the next 100 puffs, you will get a strange, muddy mix of both flavours.

The "Pod Swap" Strategy

The best way to switch flavours is to have dedicated pods.

Pod A: For your Mints and Ices.

Pod B: For your Fruits and Sweets.

Pod C: For Tobaccos or Desserts.

By swapping the entire pod (rather than just the liquid), you ensure every flavour tastes exactly as our mixologists intended.

The Zero-Cleaning Solution

If the idea of rinsing tanks and cleaning chimneys feels like too much effort, there is a simpler way.

Gold Bar Prefilled Pod Kits, like the Gold Bar Reload, Gold Bar XL and Apollo 20K, eliminate the need for cleaning almost entirely. Because the mouthpiece, tank, and coil are all one sealed unit, you throw the dirty parts away when the liquid is finished. Every time you click in a new pod, you get a fresh, sterile mouthpiece and a clean coil.

Conclusion

A clean vape is a happy vape. By spending just a few minutes once a week to rinse your pod and wipe your contacts, you ensure that your device remains hygienic and your Gold Bar Nic Salts taste crisp and clear.

Our Customer Service Team is always on hand to help you if you need further assistance or advice.

Shop Vape Kits

FAQS:

How do I get the old flavour out of my coil?

You can't really remove flavour from the cotton wick once it's soaked in. The best solution is to use a fresh coil/pod for the new flavour or stick to similar flavour profiles in the same coil.

Why does my vape crackle after cleaning?

This usually means there is still water in the pod. The crackling sound is the water boiling on the coil. Let it dry for a little longer or flick the pod firmly to dislodge trapped water droplets.

How often should I clean my vape pod?

We recommend a quick rinse every time you change your coil, or at least once a week. You should wipe the mouthpiece daily for hygiene.

Can I use soap to clean my vape tank?

We generally advise against it. If you don't rinse the soap out perfectly, your vape will taste like washing-up liquid. Warm water is usually enough to dissolve e-liquid residue.

How to Clean Your Vape Kit for Better Flavour And Hygiene

Item added to your basket

How to Clean Your Vape Kit for Better Flavour & Hygiene

Key Takeaways:

Vaporesso Xros 5 Nano Pod Vape Kit

Gold Bar Reload Ice Pop Prefilled Pod Kit

What You Need

The "Do Not Wash" List: Crucial Safety Rules